Bit addressing module items
Details of operation principle: CAN_EDCP_Programmers_Guide.pdf
Control bits
- Control:16 - disable voltage ramp speed limit
- Control:14 - set kill enable
- Control:12 - set fine adjustment
- Control:6 - do clear all events
More information can be found in the document: CAN_EDCP_Programmers_Guide.pdf
Status bits
- Status:21 - is voltage ramp speed limited
- Status:20 - is power fail ramp down in crate with UPS
- Status:19 - is initial data CRC good
- Status:18 - is process data CRC good
- Status:17 - is internal communication good
- Status:16 - is fast ramp down
- Status:15 - is kill enable
- Status:14 - is temperature good
- Status:13 - is supplies good
- Status:12 - is module good
- Status:11 - is event active
- Status:10 - is safety loop good
- Status:9 - is no ramp
- Status:8 - is no sum error
- Status:6 - is input error
- Status:5 - is hardware voltage limit good 1
- Status:4 - is service needed
- Status:3 - is high voltage on
- Status:2 - is live insertion
- Status:0 - is fine adjustment active
More information can be found in the document: CAN_EDCP_Programmers_Guide.pdf
Event status bits
- EventStatus:14 - event temperature not good
- EventStatus:13 - event supplies not good
- EventStatus:10 - event safety loop not good
- EventStatus:6 - event input error
- EventStatus:5 - event hardware voltage limit not good 1
- EventStatus:4 - event service needed
- EventStatus:2 - event live insertion
More information can be found in the document: CAN_EDCP_Programmers_Guide.pdf
Event mask bits
- EventMask:14 - mask event temperature not good
- EventMask:13 - mask event supplies not good
- EventMask:10 - mask event safety loop not good
- EventMask:6 - mask event input error
- EventMask:5 - mask event hardware voltage limit not good 1
- EventMask:4 - mask event service needed
- EventMask:2 - mask event live insertion
More information can be found in the document: CAN_EDCP_Programmers_Guide.pdf
1modules with FirmwareName E16D0 only